![]() |
|
|
Vintage Diesel and Oil Engines Fairbanks Morse, Lister, Petter, Witte and other pump injected Diesel oil engines. |
![]() |
6-71 Detroit engine mount dimensionsthis thread has 0 replies and has been viewed 254 times
|
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hi everybody!
My first attempt to place a request regarding 6-71 dimensions I think was not a good idea to reply on an existing thread - sorry ![]() Anyway - here is a new one. For an industrial 6-71 engine (1063-7305) I'm in need of the positions and sizes of the threads lateral on flywheel housing (not the SAE flange and the flywheel itself) and as well these on front end. On the flywheel side there are 4 threads on each side which have are rectangular pattern (3 inches lengthsways and 2 inches in heigth). Theres is also a "stop edge". On the front side there 2 lateral threads each on the machined face and 2 thru holes in the bracket/foot. Does anyone have drawings with "official" dimensions? Ideas/hints welcome! Thank you so much! Greetings from Germany Andreas |
Sponsored Links |
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | F o r u m | Replies | Last Post |
Detroit diesel 6-71 dimensions | Tester1 | Vintage Diesel and Oil Engines | 6 | 12-24-2018 06:16:06 AM |
Side Mount vs. Rear Mount | Rob Bryce | Steam Stationary Engines, Traction Engines, Steam Boats | 28 | 03-29-2017 12:24:44 AM |
Which way should mount engine on cart? | Farmallboy | Antique Gas Engine Discussion | 13 | 09-15-2016 02:06:58 PM |
Nelson Brothers, Detroit Engine Co., Detroit Engine Works. | John Davis | Antique Gas Engine Discussion | 3 | 04-01-2008 06:59:20 PM |
want to mount a 15 kw to a rx7 engine | KAdams | Antique Gas Engine Discussion | 5 | 12-06-2005 06:17:51 PM |