![]() |
|
|
![]() |
1910 Greeves Klusman Lathethis thread has 4 replies and has been viewed 974 times
|
![]() |
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
When I got this machine, it had been sitting outside for about 10 years. It took a lot of elbow grease to get her looking pretty again.
|
Sponsored Links |
|
#2
|
|||
|
|||
![]()
Was there supposed to be a picture?My Dad had an early geared head GK lathe when I was a little guy. I think it was a plain bearing ,threaded spindle, gear head but the head didn't run in oil. Rob
|
#3
|
|||
|
|||
![]()
I have a 22" Greaves Klusman lathe. I don't have it home yet but here are some pictures.
|
The Following 5 Users Say Thank You to Bill Hazzard For This Post:
|
||
#4
|
|||
|
|||
![]()
Bill, do you have all the gears for thread cutting with your G-K Lathe?
__________________
![]() |
#5
|
|||
|
|||
![]()
Tommy, I have some gears with the lathe but I am not sure if I have all of them. I do have the countershaft but the clutch pulley is broken.
|
![]() |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | F o r u m | Replies | Last Post |
1910 car | Oldtech | Antique Autos and Trucks | 4 | 04-07-2016 07:11:36 AM |
Lathe: Want information on your lathe? | john11139 | Machine Shop and Tool Talk | 4 | 04-08-2013 06:39:52 PM |
Help! 1910 Steam M/C Toy | uncx | Antique Engine Photos | 4 | 08-02-2011 11:57:15 PM |
1910 T. Eaton | Brian D. | Hit & Miss Gas Engine Discussion | 4 | 12-12-2005 08:55:40 PM |
1910 fairbanks H | Bob cutler | Antique Engine Archives | 1 | 03-23-2003 10:47:36 PM |